Graphic version of this page | Change how these pages look
[Image - Print Strength Bandwidth]
Home
RSQ discussion
RSQ Reporting Table
Using RSQ on air
IARU Reg. 1 recommendation
IARU Reg. 1 recommendation 2
IARU Reg. 3 recommendation
IARU Region 2 status
Station setup checklist
IMD Measurement
Signal trace samples
more samples
PSK signal modelling
About RSQ
Feedback
Newsletters
Mailing list
PSK31 signal traces samples
This page demonstrates a range of real signals taken from 20m QSOs during early December 2002, as received in Southern California, USA. The captured screen shots are using Logger32 by Bob K4CY.
The IMD noted on the images are taken directly from the value calculated by Logger32. Care was taken to pick fairly strong signals and to capture the picture during an idle point in the transmission.
Whilst this method is not thought to be especially scientific, it is believed to provide a useful relative reference.
Good quality transmission
The image below shows a range of signals, with the chosen signal in the waterfall highlighted between the two red parallel lines, just to the left of the text "14071".
The spectrum display shows the clean profile of this signal, attaining an IMD figure of -26dB.
This trace would rate a Q9 report according to the reporting tables.
Typical quality transmission
The image below shows a range of signals, with the chosen signal in the waterfall highlighted between the two red parallel lines, just to the right of the text "14071".
The spectrum display shows one pair of unwanted sidebands, attaining an IMD figure of -20dB.
This trace would rate a Q7 report.
Poor quality transmission
The image shown below demonstrates a bad signal, unfortunately all too commonly seen!
The signal is generating multiple sidebands, taking up more bandwidth than necessary, and likely causing interference to fellow amateurs.
The spectrum display clearly shows the multiple unwanted sidebands emitting from this station.
This trace would rate a Q1 report.
Non real-world signals
To see a range of non real-world traces, click here.
Sound samples
Below are a couple of .WAV audio files, highlighting the difference between a good and bad PSK signal.
Click on each one to download the sound sample - but remember to turn your volume setting down first!
Capturing the audio to a wave file, and then e-mailing to operators who are sending poor signals may assist them to better recognise their problem. Experience has shown that this type of feedback is appreciated.
Downloads
example of very good PSK signal audio (0.27 MB)
example of very poor PSK signal audio (0.27 MB)
[Image - Print Strength Bandwidth]
Have you subscribed to our mailing list? If not and would like to, click
here
Would you like to give us some feedback about RSQ? If so, click
here
Many thanks!
73, the development team.
Website sponsored by Sitekit
Solutions Ltd: powered by
SiteKit